加入WTO带给中国钼业的机遇和挑战

目前中国的钼储量和产量均列世界第二位，今后中国钼业应加快产业结构调整，拓展钼的应用领域，重点发展钼深加工产品，变资源优势为经济优势。     

利用Pd—20%Ag合金钎焊单晶钼

利用Ｐｄ－２０％Ａｇ合金钎焊单晶钼，评价了钎焊点的室温弯曲性能，检验了钎焊怪的显微组织，硬度和化学成分。     

硝酸溶液中钼和锆溶解度的测定

一、前言在核裂变过程中,钼和锆是高产额的裂变产物元素,所以在乏燃料中钼和锆的含量较高。核燃料水法后处理工艺的常用介质是硝酸,因此测定硝酸溶液中钼和锆的溶解度是有意义的。对于裂变产物的过程化学的研究工作,溶解度数据也是必要的。关于硝酸溶液中钼和锆的溶解度,前人研究得很少,数据也不全。为此,我们测定了不同浓度的硝酸中不同温度下钼和锆溶解度;还观测了硝酸根和铀浓度对钼和锆的溶解度的影响;获取的数据较全面。     

Electrochemical deposition of MoS2 thin films by reduction of tetrathiomolybdate

Molybdenum sulphide was cathodically electrodeposited from aqueous solutions of sodium tetrathiomolybdate. The as-deposited films were X-ray amorphous with a composition, measured by microprobe analysis, close to MoS₂. Annealing these films in Ar resulted in highly-textured films of MoS₂ with the van der Waals planes parallel to the substrate. A small expansion in the c spacing of the annealed films was explained by the presence of oxygen in the crystals. A direct bandgap of 1.78 eV was found for the annealed films.     

Microstructural Effects of Ion Implantation on Molybdenum

The effects of ion implantation and subsequent annealing on the microstructure of molybdenum have been investigated by transmission electron microscopy. The ions investigated were carbon, nitrogen, and tellurium. The ion-induced damage was found to give rise to grain boundary migration phenomena both during implantation and during subsequent annealing. Precipitation or ordering was found to occur for each ion on annealing.     

Kinetic study of the deep hydrodesulfurization of dibenzothiophene over molybdenum carbide supported on a carbon black composite: Existence of two types of active sites

Hydrodesulfurization (HDS) is part of the hydrotreating process, which is an ensemble of several reactions (HDN, HDO, HDS, etc.) taking place simultaneously at the industrial scale. Only sulfur is currently submitted to drastic Europeans specifications and conventional commercial catalysts cannot reach the specifications at low cost. This paper presents the behavior of a potential substitute catalyst tested for the deep HDS of a model molecule such as the dibenzothiophene (DBT). The substitute is molybdenum carbide supported on a mesoporous carbon black composite of surface area 240 m² g⁻¹. A global kinetic study of the deep HDS of DBT (300 ppm S) was performed at 623 K and 5.0 MPa and a global kinetic model was proposed as well as global rate constants were calculated to obtain theoretical plots of concentration versus contact time to compare with the experimental data. The kinetic model and global kinetic orders were confirmed as an acceptable correlation was found between calculated and experimental data. Furthermore, the determination of the global kinetic orders indicated that two types of active sites must be present on the surface in order to explain the observed results.     

二硅化钼用于钼基的耐热涂层

介绍ＭｏＳｉＯ２用于钼基的耐热涂层，进行涂层的动力、金相学和添加剂的分析。     

整体成型钼园舟研究

本研究采用特殊的方法制取钼园舟，研究结果表明，获得了满意的结果。     

钼的高灵敏显色反应及其应用

本文提出了钼的高灵敏显色反应[Mo（Ⅵ）－SCN－Morin－BPR－Twwen80体系]和在测定微量钼的应用。研究了Mo（Ⅵ）、SCN、桑色素（Morin）、溴邻苯三酚红（BPR）和吐温80（Tween80）显色配位体系的特性，该体系的最大吸收峰为565nm，最佳酸度为0．10～0．35mol／LH2SO4介质中，摩尔吸光系数ε＝3．5×106L·mol(-1)·cm(-1)，在565nm波长处空白值最低。配合物的组成比为Mo（Ⅵ）：SCN：Morin－BPR－1：6：3（在Tween80存在下）。0～2．50μgMo(6 )／50mL范围内，服从郎伯－比尔定律。回收率为98％～102％。应用此法测定土壤和头发中微量钼，获得满意的结果。